13
Original JM44/JM54 Control Panel JM44/44SHA/54/54SHA Push Button
Control Panel
3.
The
Foot Pedal
switch should be positioned on the floor within easy reach of the
operator. It is used to activate the roller when the
Auto/Foot
switch is in the “Foot”
mode. NOTE: The Foot Pedal acts as a safety device. When the mode switch is set to
the
Foot
position, the laminator will not operate unless the Foot Pedal is depressed.
4.
On the original front control panel, the
Forward/Reverse
rocker switch is used to select
the direction of the roller rotation. Upon start up, place the switch in the “OFF” position.
On the models with the push button control panel, simply push the desired button to
initiate roller movement.
Reverse only operates in Foot mode.
5. The
Speed Control
switch. Rotating the knob to the right will increase the speed of the
roller in either “Foot” or “Auto” mode. Upon start up, rotate the knob all the way to the
left to the off position.
6. The
Pressure Control Knobs
are located on the top of each side. They adjust the top
roller height and pressure. Rotate both
Pressure Control Knobs
counter-clockwise to
raise the top roller. (See “Setting Roller Pressure” to adjust the pressure properly). On
the SHA (Single Height Adjustment) models, the single hand wheel is located on the
right end case. Simply turn the hand wheel to raise or lower the top roller. The LED
readouts on the SHA, (located either on the top or the front of the right end case), will
show the roller height in millimeters and the pressure on a bar graph as percentage.
7. The
Supply Shaft
holds the adhesive or laminate material, while the
Take Up
or wind-
up shaft holds the release liner.