27
To prepare hardboard substrates for mounting, wipe down the surface with a TacCloth. If the
surface contains irregularities, use sandpaper to remove them, and then wipe the surface
with a Tac Cloth.
Please note:
Due to their highly absorbent properties, do not wipe down the surfaces of any
of these substrates (i.e. foam board, mat/millboard or hardboard) with a moist rag.
Use a Tac Cloth to wipe down foam board.
Tip: It is important that you remove dust and other debris from your prints prior to mounting.
Care and Maintenan
c
e
CAUTION: Unplug the machine before performing any service or maintenance.
Cleaning: In order for your
Jet
Mounter
™
to operate efficiently, be sure to clean it
regularly with a soft cloth. A neutral mixture of soap and water can be used for this
purpose. To remove heavy dirt and adhesive residue we suggest the use of 99%
isopropyl alcohol.
Do not use thinner or a metal brush to clean the rollers.
Rollers: In order to extend the life of your
Jet
Mounter
™
laminator it is strongly
recommended that the rollers be separated when the machine is not in use.
Fuses: There are two replaceable fuses on your
Jet
Mounter
™
located on the rear
panel where the power cord enters the machine. One is actually in the power cord
receptacle. The other is in a separate holder next to the power cord. Fuses are
5x20mm 1, 2 or 8 Amp
depending on the particular machines‟ voltage requirements.
The use of any other fuse may endanger the operator and/or machine and invalidate
the warranty.
Lubrication: Lubricate the drive chain located behind the right hand end cover every