24
Remove the hold down straps and lock the brakes on the casters. (Step 7)
Back off nut to bolt head and then turn bolt down to shaft to lower one end of the machine
at a time. (Step 8)
9. Install the ramps on the correct end of the base pallet so the casters trail away from the
ramp. The ramp may need to be angled to the side to get the bolts started. Secure
ramps in line with pallet tracks.
10. Unlock the casters. Position one person on either side of the machine and carefully
guide the machine off the base pallet down the ramps.
11. Remove the shrink wrap from the machine. DO NOT use any sharp tools near the
rollers! Follow the instructions provided in the Operator’s Manual to set up and
operate your new Pro XD. Important:
•
The JM 63 Pro XD must be on a level surface in order to operate properly.
•
The JM Pro XD requires a single phase 220 Volt power supply with a minimum
20 Amp dedicated service. Install the correct plug to match the outlet at the point
of use.
If you have any questions or need further assistance contact Drytac Technical
Services at 1-800-280-6013.
Summary of Contents for JetMounter Pro
Page 1: ...OPERATOR S MANUAL 9 16 16 ...