DS Guitar Engineering
Chronograph
User Manual v1.0.3
Revised October 31, 2016
DSGE
Chronograph
User Manual
Page
2
of
3
Navigating the Main Menu
In order to access the main menu, simply hold the footswitch for 1 second or more while the clock is being
displayed. Release the footswitch and hold it again to advance to the next menu option. Tap the footswitch to
select the option that is currently displayed on the screen. Tapping the footswitch while in clock mode will have
no effect. The three options are Clock, Countdown Timer Mode (Ctdn), and Stopwatch Mode (CtuP).
Countdown Timer Mode
After selecting Countdown Timer Mode the last used start time
will be displayed and the “minutes” value will blink once. Tap
the footswitch to increment the minutes value and hold the
footswitch to accept. The “seconds” value will blink once to
indicate the minutes value was accepted. Repeat the process for
the seconds value and the entire display will blink once to
indicate the timer has been set.
Tapping the footswitch at this point will have no effect on the
timer. This prevents you from inadvertently tapping the footswitch and accidentally starting the timer. Hold the
footswitch until the timer begins to count down. The timer can be paused at any time by tapping the footswitch.
The timer can also be reset at any time by holding the footswitch. You’ll notice that your previous start time is
recalled when the timer is reset. Hold the footswitch again to exit countdown timer mode.
The display will begin to continuously flash as a warning when the timer goes below a certain threshold. By
default this value is 1 minute. Boot the Chronograph in Setup mode to change this value.
Stopwatch Mode
After selecting Stopwatch Mode the display should read “00:00”.
Tapping the footswitch will start, pause, and resume the
stopwatch. Holding the footswitch will reset the stopwatch.
Hold the footswitch again after resetting it to exit Stopwatch
Mode and return to Clock Mode.
