Access Codes
Command Outputs ([*][7][1], [*][7][2], [*][7][3], and [*][7][4]):
If these outputs require access
code entry, any Access Code with partition access will be valid for performing the command output func-
tions on that partition.
Programmable Attributes
1. Supervisor Code
5. For Future Use
2. Duress Code
6. For Future Use
3. Zone Bypassing Enabled
7. Bell Squawk upon Arming/Disarming
4. Remote Access
8. One Time Use Code
Bell Squawk Attribute
This attribute is used to determine whether an access code should generate an arming/disarming Bell
Squawk upon entry of the code for Away arming. The wireless keys with access codes associated with them
may generate Arming/Disarming Bell squawks. If desired, this option may be used with codes that are manu-
ally entered. Please contact your installer to have this programmed.
Note:
The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other codes.
Note:
This feature cannot prevent the Arming/Disarming squawks from being generated if an access code
assigned to a wireless key is manually entered at a keypad.
Note:
This feature is used to annunciate fire trouble signals and also trouble conditions for medical applic-
ations.
Partition Assignment
1.
This section is used to assign users to available partitions. To assign partitions:
2.
Select Options > Access Codes.
3.
Enter the master code.
4.
Select a user.
5.
Select Partition Attributes.
6.
Select the partition(s) to assign to the user.
Notes on Access Codes and Programming
l
The master code’s attributes cannot be changed.
l
When a new code is programmed in User Programming it will be checked against all other codes
in the system. If a duplicate code is found, an error tone is given and the code is returned to what
it was before it was changed. This applies to both 4 and 6-digit codes.
Erasing an Access Code
To erase a code, select the code and choose Delete User. The system will delete the code immediately and
the user will be returned to select another code.
Installer Menu
These functions are for the installer’s use only.
- 19 -
