User Functions
Important:
l
To ensure that your system continues to function as intended, you must test your system weekly.
l
For UL HOME HEALTH CARE listed applications, the system shall also be tested weekly
without AC power. To remove AC from the control unit, remove the screw from the restraining tab
of the plug in adapter and remove the adapter from the AC outlet. After completing the test of the
unit using only the battery backup source, reconnect the plug in adapter and attach the screw
through the restraining tab, so that the adapter is securely attached to the outlet.
l
Should your system fail to function properly, contact your installation company immediately.
l
All smoke detectors must be tested by your smoke detector installer once a year to ensure proper
operation.
Auto-Arm/Disarm Control
Pressing Auto-Arm while in the User Function menu will enable (three beeps) or disable (one long beep) the
Auto-Arm and Auto-Disarm feature, by partition. With this feature enabled, the panel will automatically arm
in Away mode (Stay/Away zones active) or disarm at the same time each day. The Auto-Arm time is pro-
grammed with the Auto-Arm time button. Auto-Disarm must be programmed by the system installer.
User Call-up
If enabled by the installer, the panel will make 1 attempt to call the downloading computer. The down-
loading computer must be waiting for the panel to call before downloading can be performed.
Engineer's Reset
If an alarm has occurred on your system, the system will not allow you to rearm (Ready light is OFF). You
will need to contact your installer. They will check and reset the system for you. This may involve a visit
to check your system. After the reset is performed, your system will function properly again.
- 21 -
