14
T E S T I N G & M O U N T I N G
If you move the LCD5501Z32-900, repeat the tests
described in sections 5.1 and 5.2 on all the wireless
devices. Continue to test the devices until you
h a v e f o u n d s a t i s f a c t o r y l o c a t i o n s f o r t h e
LCD5501Z32-900 and the WLS904, WLS905,
WLS906 and WLS907 devices, and there is good
reception between the LCD5501Z32-900 and the
WLS908, WLS909 and WLS910 devices.
Mount the WLS904, WLS905, WLS906,
WLS907, and WLS915 Devices
If you have conducted the placement test described
in section 5.1 and got 3 “Good” or “Fair” results in a
row for each device, you can mount the wireless
devices. See the Installation sheet for each device
for mounting instructions.
5.3 Battery Test for WLS908 Panic
Pendants
You cannot test Panic Pendant batteries using the
methods described in sections 5.1 and 5.2. You must
program panic pendant zones before you can test
the panic pendants.
NOTE: If a low battery condition is detected, you must
immediately replace the unit.
Follow these steps to test panic pendants:
1. Begin testing when your system is in the ready
state and the keypad Ready light is on.
2. Go to an LCD keypad.
NOTE: If your system is partitioned, you can only view
the Panic Pendant test result on a partition LCD
keypad. To view the test result on a global LCD key-
pad, you must “loan” the keypad to the partition before
you begin the test. See your Installation Manual for
information on global and partition keypads.
3. Press and hold the “Test” button on the pendant
for two seconds.
4. If the pendant’s battery condition is
normal, the
Ready light on the LCD keypad will turn OFF for
30 seconds or until the [#] key is pressed. On the
PC5010, PC5015, PC5008, PC1555 and PC580
v2.x or higher: If the pendant’s battery condition
is normal, the keypad will beep and the LCD
keypad will display “System Test in Progress.”
If the pendant’s battery is
low, the LCD keypad’s
Trouble light will turn ON and the keypad will give
a series of continuous beeps.
Instruct the user(s) to perform this test when they
perform the weekly system test.
NOTE: If a low battery condition is detected, you must
immediately replace the unit.
Replacing a Pendant with a Low
Battery
You should immediately replace a pendant when a
low battery is indicated. To replace a pendant on the
system, follow these steps:
From the keypad:
1. Enter [
✱
][8][Installer Code].
2. Enter programming Section [804].
3. Enter the 2-digit zone number of the pendant to
be replaced (01-32).
4. Enter serial number [000000].
5. Re-enter the 2-digit zone number for the pendant
being replaced.
6. Enter the ESN of the new pendant.
7. To exit press [#] twice.
Through downloading:
1. Connect to the control panel through
downloading.
2. Upload window contents of the zone serial
numbers in the wireless expansion section of
downloading.
3. Change the serial number of the pendant to be
replaced to [000000].
4. Download window contents.
5. Enter the ESN of the new pendant.
6. Download window contents.
