DSC PC1150, Instruction Manual

 format   

 reporting

Requires:

l 

 account code in sections 

 or 

 For example, enter 1230 for account code 123

l 

Format Code [0], 

 depending on receiver type in section 

l

Single line 

 Alarm Reporting Code Section 

 For example, enter 

 for 

single digit code 3 (0 = no pulses)

TRANSMISSION SENT: 123 3

 Format   Non-extended reporting

Requires:

l 

4-digit account code in sections 

 or 

 For example, enter 1230 for account code 123

l 

Format Code [0], 

 depending on receiver type in section 

l 

 Alarm Reporting Code in section 

 For example, enter 

 for 2-digit code 31

TRANSMISSION SENT: 1234 31

 Format   Extended reporting

Requires:

l 

 Account Code in section 

 or 

 For example, enter 1230 for code 123

 Format Code 

 [A], 

 [C] depending on receiver type in section 

l 

 Alarm Reporting Code in section 

 For example, enter 

 for 2-digit code 31

TRANSMISSION SENT: 1 

st ROUND

123 3

2nd ROUND 333 1

If a transmission is not needed for a particular reporting code, enter [00] or [FF] to disable that reporting code.

 Zone 

 Reporting Codes

Zone 

 Codes are transmitted when zones 1 through 6 are restored from an alarm condition. Refer to

Section 

 for programming instructions.

 (Arming) Reporting Codes   Partial 

 Reporting Code

Closing Reporting Codes are transmitted to 

identify 

arming 

of the system 

by 

Access Codes 1 through 6. If Partial

Closing is identified in Section 

 the alarm codes for manually bypassed zones will be transmitted when the

system is armed with one or more zones bypassed. Refer to Section 

 for programming instructions. The

Closing Reporting Codes may be programmed as follows:

The first digit, HEX ‘C’, represents “closing”, and the second digit represents the Access Code which was used
to arm the system. Note that any number or HEX digit may be used for the first digit; check with the intended
monitoring station to determine their reporting code preferences.

The Closing Code transmission takes place 

after 

the Exit Delay. If the system is 

armed 

and then disarmed before

the Exit Delay expires, no closing transmission will take place.

The partial closing code, if used, is transmitted with the regular closing code to identify a partial closing.

When the system has been armed using the 

 Quick-Arm command or the Auto-Arm feature,

Access Code 1 will be transmitted.

15

firealarmresources.com