DSC PowerSeries PTK5507, Installation Instructions Manual

REQUIREMENTS OR THAT OPERATION OF THE SOFTWARE WILL BE

UNINTERRUPTED OR ERROR-FREE.

(b) CHANGES IN OPERATING ENVIRONMENT - 

DSC shall not be responsible for

problems caused by changes in the operating characteristics of the HARDWARE, or for problems

in the interaction of the SOFTWARE PRODUCT with non-DSC-SOFTWARE or HARDWARE

PRODUCTS.

(c) LIMITATION OF LIABILITY; WARRANTY REFLECTS ALLOCATION OF RISK

 -

IN ANY EVENT, IF ANY STATUTE IMPLIES WARRANTIES OR CONDITIONS NOT

STATED IN THIS LICENSE AGREEMENT, DSC’S ENTIRE LIABILITY UNDER ANY

PROVISION OF THIS LICENSE AGREEMENT SHALL BE LIMITED TO THE GREATER OF

THE AMOUNT ACTUALLY PAID BY YOU TO LICENSE THE SOFTWARE PRODUCT AND

FIVE CANADIAN DOLLARS (CAD$5.00). BECAUSE SOME JURISDICTIONS DO NOT

ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR

INCIDENTAL DAMAGES, THE ABOVE LIMITATION MAY NOT APPLY TO YOU.

(d) DISCLAIMER OF WARRANTIES - 

THIS WARRANTY CONTAINS THE ENTIRE

WARRANTY AND SHALL BE IN LIEU OF ANY AND ALL OTHER WARRANTIES,

WHETHER EXPRESSED OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) AND OF ALL

OTHER OBLIGATIONS OR LIABILITIES ON THE PART OF DSC. DSC MAKES NO

OTHER WARRANTIES. DSC NEITHER ASSUMES NOR AUTHORIZES ANY OTHER

PERSON PURPORTING TO ACT ON ITS BEHALF TO MODIFY OR TO CHANGE THIS

WARRANTY, NOR TO ASSUME FOR IT ANY OTHER WARRANTY OR LIABILITY

CONCERNING THIS SOFTWARE PRODUCT.

(e) EXCLUSIVE REMEDY AND LIMITATION OF WARRANTY 

- UNDER NO

CIRCUMSTANCES SHALL DSC BE LIABLE FOR ANY SPECIAL, INCIDENTAL,

CONSEQUENTIAL OR INDIRECT DAMAGES BASED UPON BREACH OF WAR-

RANTY, BREACH OF CONTRACT, NEGLIGENCE, STRICT LIABILITY, OR ANY

OTHER LEGAL THEORY. SUCH DAMAGES INCLUDE, BUT ARE NOT LIMITED

TO, LOSS OF PROFITS, LOSS OF THE SOFTWARE PRODUCT OR ANY ASSOCI-

ATED EQUIPMENT, COST OF CAPITAL, COST OF SUBSTITUTE OR REPLACE-

MENT EQUIPMENT, FACILITIES OR SERVICES, DOWN TIME, PURCHASERS

TIME, THE CLAIMS OF THIRD PARTIES, INCLUDING CUSTOMERS, AND

INJURY TO PROPERTY. 

WARNING: DSC recommends that the entire system be completely tested on a regular

basis. However, despite frequent testing, and due to, but not limited to, criminal tampering

or electrical disruption, it is possible for this SOFTWARE PRODUCT to fail to perform as

expected.FCC Compliance Statement - CAUTION: Changes or modifications not

expressly approved by DSC could void your authority to use this equipment.

This equipment generates and uses radio frequency energy and if not installed and used properly, in

strict accordance with the manufacturer’s instructions, may cause interference to radio and television

reception. It has been type tested and found to comply with the limits for Class B device in accor-

dance with the specifications in Subpart “B” of Part 15 of FCC Rules, which are designed to provide

reasonable protection against such interference in any residential installation. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

interference to television or radio reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following mea-

sures:

• Re-orient the receiving antenna

• Relocate the alarm control with respect to the receiver

• Move the alarm control away from the receiver

• Connect the alarm control into a different outlet so that alarm control and receiver are on different

circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for

additional suggestions. The user may find the following booklet prepared by the FCC helpful: “How

to Identify and Resolve Radio/Television Interference Problems”. This booklet is available from the

U.S. Government Printing Office, Washington, D.C. 20402, Stock # 004-000-00345-4.

Operating Instructions shall be made available to the user.

The trademarks, logos, and service marks displayed on this document are registered in the

United States [or other countries]. Any misuse of the trademarks is strictly prohibited and

Tyco International Ltd. will aggressively enforce its intellectual property rights to the fullest

extent of the law, including pursuit of criminal prosecution wherever necessary. All trade-

marks not owned by Tyco International Ltd. are the property of their respective owners, and

are used with permission or allowed under applicable laws. Product offerings and specifica-

tions are subject to change without notice. Actual products may vary from photos. Not all

products include all features. Availability varies by region; contact your sales representative.

This product contains open source components QT Version 4.7.3 and Linux Kernel

License: Version 2.6. Both of these components are protected by copyright and have terms

and conditions associated with their use. The open source software code and associated

components used in this product are downloadable from the DSC website. Please visit 

http://www.dsc.com/open-source-documentation for detailed information.

This Class B digital apparatus complies with Canadian ICES-003. 

©2013 Tyco International Ltd. and its Respective Companies. All Rights Reserved. Toronto, Canada • 
www.dsc.com • Tech Support: 1-800-387-3630 (Canada, US), 905-760-3000 Printed in Canada