OPERATING THE POWERMASTER SYSTEM
12
D-306232 WP8010/WP8030 V18 DSC EN USER
Forced arming “HOME” is performed in a similar manner, as follows:
PRESS
RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE
_ _ _ _
[Enter code] /
[Present tag]
Code / Present tag
ARMING HOME
PLEASE EXIT NOW
(to mute the buzzer)
Go to interior zone
(Exit delay)
HOME HH:MM
ARM indicator
flashes during the armed state.
Arming in the Latchkey Mode
This mode, if enabled by the installer, is useful for a parent at work who wants to be sure that his children have
returned from school and have disarmed the system. A special “latchkey” message will be sent out when the
system is disarmed by a “latchkey user”.
Latchkey users are holders of user codes or users of keyfob transmitters 5 through 8 (WP Panel) / 23-32 (WP
Panel). The latchkey message is considered an alert and not an alarm, and is therefore sent to the private
telephones programmed by the user as targets for alert messages.
Latchkey arming is possible only when you arm “AWAY”. To arm in the Latchkey mode, proceed as follows:
PRESS
RESULTING DISPLAY
ARMING AWAY
ARMING LATCHKEY
(Within 2 seconds)
(alternating)
PLEASE EXIT NOW
Vacate the premises
(Exit delay)
AWAY
Note:
Latchkey must be enabled by your installer.
ARM indicator
lights during the armed state.
Initiating Alarms
Following are various methods that may be used for initiating alarms.
Initiating Panic Alarm
You can generate a panic alarm manually in the disarmed and armed states. The sequence will be as shown:
PRESS
RESULTING DISPLAY
PANIC ALARM
simultaneously
READY HH:MM
To stop the alarm, press the
button and then key in your valid user code.
