Document:
RE-BCC DCC 1F7
Document:
RE-BCC DCC 1F7
Document:
RE-BCC DCC 1F7
Page:
2
Page:
2
OWNER'S MANUAL
RE-RE-BCCxx DCCxx analog and AHD waterproof cameras with IR
DSE srl - Digital Surveillance Equipment -
WWW.DSE.EU
DSE srl - Digital Surveillance Equipment -
WWW.DSE.EU
Models with normal IR (850 nm) LEDs are visible in the dark to a light reddish luminescence.
The models at 940 nm are invisible in the dark.
Programming Menu OSD
Many models in this range are used to configure various display options through
an on-screen menu (OSD) To control the on-screen menu you act on mini joystick
located along the camera cable. Also all cameras with OSD have a UTC chip that
lets you control the programming menu also acting from the opposite end of the
video cable (DVR side) using the remote control
RE-RE-UTC or by UTC2
ordered separately. The remote control RE UTC can only be used with video output in analog
ordered separately. The remote control RE UTC can only be used with video output in analog
mode while the RE-UTC2 model can also be used with video output in AHD mode (see below)
mode while the RE-UTC2 model can also be used with video output in AHD mode (see below)
Our latest DVR PTZ menu include in the UTC option to directly control the UTC menu of the
camera directly from the DVR without the need for external controller.
OSD Options
For explanations of the various OSD options refer to the separate instructions.
AHD Technology (
models xxxHDU xxxFDU)
AHD Technology (
models xxxHDU xxxFDU)
All cameras in this range support AHD technology and
are
able to
work with both normal DVR
analog and DVR with AHD last generation with which allow you to reach the HD720P resolution
1280x720 and 1920x1080 FULL HD 1080P.
The xxxHDU models support AHD 720P, while xxxFDU AHD models support 1080P.
A AHD 720P camera can be connected to any DVR AHD and display the 1280x720 resolution.
A AHD 1080P camera requires AHD 1080P DVR shows and 1920x1080 resolution.
Switch AHD / CVBS (
mod. xxxHDU xxxFDU)
Switch AHD / CVBS (
mod. xxxHDU xxxFDU)
The AHD cameras are always provided in AHD mode but can be switched into traditional
analogue CVBS mode if you need to connect to old or DVR directly to a TV.
The switching between the two systems is done by the Mini Joystick OSD in the following
manner:
METHOD
AHD:
Keep the mini joystick in position for 5 seconds RIGHT MODE
ANALOG
METHOD
AHD:
Keep the mini joystick in position for 5 seconds RIGHT MODE
ANALOG
METHOD
AHD:
Keep the mini joystick in position for 5 seconds RIGHT MODE
ANALOG
METHOD
AHD:
Keep the mini joystick in position for 5 seconds RIGHT MODE
ANALOG
VIDEO / CVBS:
Keep the mini joystick in LEFT position for 5 seconds
VIDEO / CVBS:
Keep the mini joystick in LEFT position for 5 seconds
4in1 Technology (
xxxFD4 models)
4in1 Technology (
xxxFD4 models)
Some cameras in this range (i xxxFD4 models) support in addition to CVBS technologies and
AHD also CVI 1080P 1080P and 1080P TVI technologies. It is
analog technologies in high resolution, similar to AHD but used by other
builders.
In this case the
switching is performed as follows:
xxxFD4
xxxFD4R and RE-DCC1FD4
As can be seen in the table, the switching is carried out in a slightly different way for models with
invisible IR (xxxFDR) and for minidome models (RE-DCC1FD4). In this model it is also necessary
to interrupt and restore power to the camera before performing the switching.
3MP Technology (
xxxM4 models)
3MP Technology (
xxxM4 models)
The 3MP camera (RE ---- M4) do not support CVBS and do not require switching. E 'can switch
between AHD and TVI formats
4MP Technology (
xxxN models)
4MP Technology (
xxxN models)
The 4MP cameras (RE ---- N) support in AHD and CVBS formats. The switching is performed in
the following manner. The selection Real Time / No Real time affects the resolution of the camera
(No Real time = 4MP 12 f / s, Real Time Half4MP = 25 f / s). To adjust to the DVR remote control
of UTC menu must set Real Time.
Main technical data
www.dseitalia.it/dati_telcavo.htm
