DSE7110 & DSE7120 Operator Manual
9
3.5.3
CHARGE FAIL INPUT
Minimum voltage
0V
Maximum voltage
35V (plant supply)
Resolution
0.2V
Accuracy
± 1% of max measured voltage
Excitation
Active circuit constant power output
Output Power
2.5W nominal at 12V and 24V
Current at 12V
210mA
Current at 24V
105mA
3.5.4
MAGNETIC PICKUP
Type
Single ended input, capacitive coupled
Minimum voltage
0.5V RMS
Max common mode voltage
±2V
Maximum voltage
Clamped to ±70V by transient suppressers, dissipation not to exceed 1W.
Maximum frequency
10,000Hz
Resolution
6.25 RPM
Accuracy
±25 RPM
Flywheel teeth
10 to 500
3.6
OUTPUTS
3.6.1
OUTPUTS A & B (FUEL AND START)
Type
Fuel (A) and Start (B) outputs. Supplied from DC supply terminal 2.
Fully configurable when CAN engine is selected.
Rating
16 @ 35V
Protection
Protected against over current & over temperature. Built in load dump feature.
3.6.2
CONFIGURABLE OUTPUTS C & D
Type
Fully configurable, Volts Free. C=normally closed, D=normally open. Usually used for gen/mains load switch
control.
Rating
8A resistive @ 250V
Protection
Protected against over current & over temperature. Built in load dump feature.
3.6.3
CONFIGURABLE OUTPUTS E, F, G & H
Type
Fully configurable, supplied from Emergency Stop terminal 3.
Rating
2A @ 35V
Protection
Protected against over current & over temperature. Built in load dump feature.
3.7
COMMUNICATION PORTS
USB Port
USB2.0 Device for connection to PC running DSE configuration suite only
CAN Port
(not applicable to
7110-xxx-01
MPU version)
Engine CAN Port
Standard implementation of ‘Slow mode’, up to 250 kbits/s
Non Isolated.
Internal Termination provided (120
Ω
)
3.8
ACCUMULATED INSTRUMENTATION
NOTE: When an accumulated instrumentation value exceeds the maximum number as listed below, it will reset
and begin counting from zero again.
Engine hours run
Maximum 99999 hrs 59 minutes (approximately 11yrs 4months)
Number of starts
99,999
CALL US TODAY
1-888-POWER-58
REQUEST A QUOTE
parts@genpowerusa.com
SHOP ONLINE
www.genpowerusa.com
