Chapter 4 Integration with PBX
4-11
3.
Enter Function Code [214] (Ringback CPT 1
st
High). Press [1#] when it prompts
you to “Press 1 to edit, 2 to save, 3 to replay”. This will force IM1200 to call the
ACPL extension.
4.
After ringing the ACPL extension a few times, it will reconnect to you and
announce the value it has calculated and set for Ringback CPT 1
st
High based on
the ringback pattern it just heard.
Note:
It also has calculated and set other Ringback CPT parameters such as Ringback CPT 1
st
Low, Ringback CPT 2nd High/Low (when available), and Ringback CPT Cycle.
5.
Press 2 to save the parameter.
6.
Take the phone of the ACPL extension off-hook, to create the Busy condition.
7.
Enter Function Code [219] (Busy 1
st
High). Press [1#] when it prompts you to
“Press 1 to edit, 2 to save, 3 to replay”. This will force IM1200 to call the ACPL
extension.
8.
It will analyze the Busy Call Progress Tone coming from the ACPL extension and
announce the value it has determined and set for the Busy 1
st
High parameter
Note:
It also has determined and set other Busy CPT parameters such Busy CPT 1
st
Low,
Busy CPT 2nd High/Low (when available), and Busy CPT Cycle.
9.
Press 2 to save the parameter.
10. You have completed the Automatic Call Progress Learning process and assigned
all the right values for the Ringback and Busy Call Progress Tone parameters to
IM1200.
DTMF Signal
Some PBX sends DTMF Signals as well as Call Progress Tones to indicate call transfer status.
Similar to the CPT, the DTMF Signal will convey the current extension status.
To set up Supervised Mode using DTMF Signal
1. Choose
System Parameters > PBX Parameters.
2. Click
Edit
tab, a
PBX Parameters
dialog page appears.
3. Choose
the
Supervised
tab.
4. Select
DTMF Signal
as the
Supervised Signal Type.
5. Define the following parameters using the codes in the DTMF and Action Code Table
(Table 4-1):
Ringback Signal
Ringback Signal indicates the extension is ringing back.
Busy Signal
Busy Signal indicates the extension status is busy.
DND Signal
DND Signal indicates the extension status is Do-Not-Disturb.
Summary of Contents for IM 2000
