Chapter 3 Configuring Your IP1200C 23
If there is any system error or you forget your IP1200C’s IP address or Telnet password, you may reset IP1200C
back to the factory default.
Step 1 Press and hold the DEFAULT button at the front panel of IP1200C.
Step 2 When holding the DEFULT button, switch off the power and trun it on. The power switch is at the rear
side of IP1200C.
Step 3 After the power is on, you will see the MODE LED is blinking. At this moment, you can release the
DEFAULT button.
The settings below will be restored to the factory default. You can connect to your IP1200C using the
default settings. The other items you’ve changed will not be reset to the factory default.
IP Address: 192.168.1.200
Gateway IP: 192.168.1.254
Subnet Mask: 255.255.255.0
DNS: 168.95.1.1
Telnet password: 0000
Summary of Contents for IP1200C
Page 1: ...07I12CM ENC Voice Communication for Free High Performance Embedded VoIP Gateway...
Page 8: ......
Page 12: ......
Page 26: ......