30 Chapter 5: IP1200C Monitor Utility
Configuration Settings
From the IP1200C Monitor Utility, you can also configure the settings of each IP1200C gateway. Please click on
the “
Configuration Setting”
icon and the “Setting Config” window will pop-up.
On the pop-up window, you may configure the following settings in “
Page 1
.”
*
Auto reboot:
If you would like to change your IP settings, you need to check the checkbox of “Auto reboot” to
edit IP Address, Gateway IP, Subnet Mask, or DNS. After the IP setting is revised, click “Save” and your
IP1200C gateway will reboot automatically.
*
Play Volume [1-9]:
This item allows you to adjust the level of receiving volume. The larger number of level
provides louder voice for you.
*
Record Volume [1-9]:
This item allows you to adjust the level of your transmitting volume. The larger
number of level provides louder voice for your receiver.
*
Echo cancellation [0-2]:
This item allows you to select the cancellation level of echo. With the higher level,
you can reduce the echo.
*
Long Distance Code:
Here you can enter the long distance code of your area.
*
International Code:
Here you can enter the international code.
*
Country Code:
Here you can enter the country code of your country.
*
Password for FXS:
The FXS interface provides connection to internal telephony equipment such as extension
analog phone, modem and a conventional PBX trunk-side. After you setup a password for FXS, access to
IP1200C FXS ports will be required to input the FXS password.
Summary of Contents for IP1200C
Page 1: ...07I12CM ENC Voice Communication for Free High Performance Embedded VoIP Gateway...
Page 8: ......
Page 12: ......
Page 26: ......