17 |
P a g e
014010-001 Rev 01
©2019 Data Sciences International.
The cartridges should be cleaned at the end of every day that any number of cigarettes have been smoked. The
purpose of this daily cleaning is to prevent liquid tar from accumulating and drying out over time, creating a sludge
that will
negatively affect the generator’s performance.
1.
Locate the two smoke cartridges in the left side panel of the generator.
2.
Remove the three knurled retaining screws (marked with a red arrow in Figure 20) that attach each cartridge
to the generator.
Figure 20
3.
Pull the cartridges out of the generator and place them in a glass container with enough isopropyl alcohol
(IPA) to completely submerge the cartridges. Keep the cartridges submerged overnight to soak.
4.
After soaking overnight, dry the cartridges (both inside and outside) with a paper towel, reinsert them into the
generator, and re-install the three retaining screws, which should be hand tightened. Note that the position of
the screw holes in the left and right cartridge prevents you from inserting a cartridge in the wrong hole. If the
holes won’t align, the cartridge is in the wrong hole.
BRUSHING OUT THE CARTRIDGES AND GREASING THE O -RINGS
