System Installation
96M4011o User’s Manual
3-1
Chapter 3
System Installation
This chapter provides you with instructions to set up your system. The additional
information is enclosed to help you install M-systems Flash disk, set up onboard PCI
device and handle WDT operation in software programming.
3.1
Pentium 4 Processor
Installing 478 Pin CPU
1) Lift the handling lever of CPU socket outwards and upwards to the other end.
2) Align the processor pins with pinholes on the socket. Make sure that the notched
corner or dot mark (pin 1) of the CPU corresponds to the socket’s bevel end. Then
press the CPU gently until it fits into place. If this operation is not easy or smooth,
don’t do it forcibly. You need to check and rebuild the CPU pin uniformly.
3) Push down the lever to lock processor chip into the socket once CPU fits.
4) Follow the installation guide of cooling fan or heat sink to mount it on CPU
surface and lock it on the socket 478.
Note:
You should know Pentium 4 processor need extra 12V power source. DON’T
FORGET TO CONNECT 4pin 12V connector to J26!
Removing CPU
1) Unlock the cooling fan first.
2) Lift the lever of CPU socket outwards and upwards to the other end.
3) Carefully lift up the existing CPU to remove it from the socket.
4) Follow the steps of installing a CPU to change to another one or place handling
bar to close the opened socket.
Configuring System Bus
96M4011o
will automatically detect the CPU used. CPU speed of Intel P4 can
be detected automatically.
