PWR-DSP1
User Manual
Page 16 of 23
Copyrights DSP4YOU ltd
4.2.3.3
Source selection
Either controlled from the switch at the back of the unit or from software, you can select the audio source between:
-
Analog audio from the 2 x XLR connector at the back of the PWR-DSP1
-
Network audio from another AVB device on the network
Note: Network audio (AVB) selection is only available for plug-in with the software AVB option enabled.
4.2.3.4
Input control
The PWR-DSP has monitoring, digital gain and mute control .
In analog mode (Up to 2ch from XLR), the following dialog box is displayed.
In Network (AVB) mode (Up to 3ch may be streamed), the following dialog box is displayed.
The lock Ratio feature allows all input faders to be “ganged” together and act as one. A useful feature as a Master
volume control of the device.
4.2.3.5
Parametric Equalizer (PEQ) control
Up to 6 bands of PEQ on each input/output section is available. For each band, the typical PEQ settings go as follow:
o
Frequency (Freq): Using the slider or text box, enter the center frequency of the PEQ filter
o
Gain: controls the boost or dip of the equalizer
o
Q: Controls the number of octaves over which the filter affects the signal
o
Type: Peak/High shelf/Low shelf
o
Bypass: Control on a per band basis whether the PEQ is enabled or not.
Fader controlling the
digital input gain
RMS meter displaying the
input level in dBFS
Input mute
Audio metering selection
Lock ratio of Ch1&2 for
ganged fader behavior
