A
NTI
-M
ODE
TM
X2
U
SER
’
S
G
UIDE
Tone Control
d
opens the real-time tone adjustment. You can adjust bass, midrange, and
treble according to your personal preference. Use
g
and
h
to select a region
to adjust. Use
f
and
e
to adjust filter gain in the chosen region.
Keep
i
pressed to fine tune the parameters of each filter. Bass and Treble
filters support adjustable range. Use
g
and
h
to make the range narrower or
wider. Press
d
or
i
to accept the new value, or
a
to cancel the
adjustment.
The mid-range filter supports user-selectable range and also a variable center
frequency. After choosing the range, at the "Fc" prompt, use
g
and
h
to
select a new center frequency. Target frequency is shown in kilohertz (kHz) unit
on the display, e.g. "1.5" means a center frequency of 1500 Hz. Press
d
or
i
to accept or
a
to cancel the adjustment.
By-Pass Mode
Pressing
d
and then
b
enters a bypass mode. In this mode the Anti-Mode
TM
room correction is not active. Some enhancements made by the system remain
active. These include the crossover between subwoofer and main channels in
the 2.1 configuration and speaker level matching. Press any button to leave the
bypass mode, then
d
or
i
to return to the home screen
Subwoofer Output Level
Pressing
d
and then
c
allows to change the relative subwoofer level. This
setting is only relevant if you have calibrated with the 2.1 configuration.
Pressing
c
again returns to the tone control view, then
d
or
i
returns to
the home screen.
Sound Profiles
Anti-Mode X2 supports 3 sound profiles that can be used to store different
settings for different situations. You can switch between the profiles in real
time by pressing the
c
button. Use the
f
and
e
to select a profile when
prompted and
i
to confirm.
Each sound profile can store different room calibration data, tone control preference and subsonic filter.
Rev. 1.1
2022-08-10
Page 7 (12)
