* Fire protection / PA system
Digital Programming Conference System
3
2)
System right/left audio output jack (AUDIO OUT). (The jacks are connected to power amplifier)
3)
System audio unbalanced output jack (NO BALANCED OUT). (Connected to power amplifier)
4)
System audio balanced output port (BALANCED OUT). (Connected to the power amplifier, the
output signal is not controlled by control unit tone adjustment.)
5)
System connection port 8P-DINX3 (LONE). (Connected to microphone units)
6) Interface has not been enabled.
7)
AC220 power outlet (AC).
3.
Operation Instructions of MP9866
3.1 System Connection
3.2 Function Mode Setup
Connect the system as per the connection diagram and press the power switch to turn on the power. Select the
operation mode of the system according to the requirements of conference. For control unit setup, there are three
kinds of principal mode: Fully Free mode (Free), First-In-First-Out mode (Fifo) and, Limit mode (Limit). Only
one of the three modes can be selected. If the mode indicator is lit, it means that mode is active. Each principal
mode can include the following three kinds of subsidiary modes: Chairman Only mode, Auto Power Off and
Chairman Priority Music prompt. (These three kinds of subsidiary modes may coexist with the principal mode
entirely or separately.)
AMP
AC 220V
CM61
CM61
CM61
CM61
CM61
CM60
