• 5 •
4.
When the condition indicator turns steady
green, crank the engine right away.
(The ability for an engine to continue to
run without a battery connected will vary,
depending on the make and model of the
vehicle).
WARNING:
Do not leave the engine running
without a connection to the jump starter or
the battery. Failure to comply could result in
damage to the vehicle ECU. The manufacturer
will not accept responsibility for any damage
caused by incorrect use of this product.
5.
As soon as the engine starts, and keeping
the jump starter clamp and battery lead
connected, attach the positive lead to the
positive battery terminal and tighten the
terminal clamp (fig. 2). After the positive
lead has been secured to the battery
terminal, switch off the jump starter and
disconnect from the battery.
Glow Mode:
In cold weather, the glow plugs in most diesel
vehicles will energize first to heat up the
engine chamber before the engine start, as
indicated by the GLOW sign on the dashboard.
The process needs a current of 40-60Amp and
takes about 4-6 seconds. In this case, after the
jump starter is fully recharged and connected,
press the GLOW button, and then turn on the
ignition.
NOTE:
GLOW is inactive during Override
Mode.
Lithium Back-up Battery Pack
This jump starter is equipped with a lithium
battery pack. Recharge the battery pack
with the micro USB charging cable and USB
charger (included). Once connected to a USB
charger, charging starts automatically.
Recharge time is approximately 5-8 hours.
The battery level indicators will show battery
status. Fully recharge the lithium battery
pack at least once a year or after using
Override Mode 2-3 times.
Working Cycle
• Maximum of 3 consecutive jump starting
operations.
• Allow a 20-minute interval between each
session.
6. SPECIFICATIONS
Input .....................................................................................................12V DC 10A, 5V DC 2A
Working temperature ............................................................... -40°C to 65°C (-40°F to 150°F)
Starting current ................................................................................................................. 900A
Battery pack ..................................................................................... Lithium, 11.1V / 2200mAh
Recharge time from vehicle battery ...................................................................... 130 seconds
Recharge time from 12V socket.................................................................................4 minutes
Recharge time from lithium battery .........................................................................5-6 minutes
7. REPLACEMENT PARTS
12V DC cig charging cable ................................................................................. 3899003573Z
Micro-USB charging cable .................................................................................. 3899003781Z
Lithium battery pack ............................................................................................ 5799000052Z
8. FREQUENTLY ASKED QUESTIONS
Q:
Is this jump starter safe for the ECU and car’s computer?
A:
Unlike traditional jump starters, this jump starter uses ultracapacitors instead of a battery.
The voltage of capacitors is restricted to a range which is safe for all kinds of ECU.
Therefore, there is no risk from overvoltage.
Capacitors have a very small capacity, about 0.2-0.4Ah. They will fully recharge from the
alternator within couple seconds once the vehicle is started. Disconnecting the jump starter
will not cause any load dump, so there is no voltage spike produced.
