DT301C/ DT301S
OPERATION
Powering ON and OFF
To ac
ti
vate the DT301C/ DT301S, push and quickly release the Power Bu
tt
on. The display
will come on in a few seconds. To put the DT301C/ DT301S in Standby mode, push and
quickly release the Power Bu
tt
on. To turn the DT301C/ DT301S o
ff
for extended storage,
power o
ff
safely using any so
ft
ware func
ti
on that “shuts down computer” provided in the
so
ft
ware opera
ti
ng system.
NOTE:
The ba
tt
ery pack shipped with your tablet may be low in power. Please use the
AC-DC adapter with the DT301C/ DT301S when se
tti
ng up for the
fi
rst
ti
me to
fully charge the ba
tt
ery pack, or use the op
ti
onal ba
tt
ery charger kit.
NOTE:
When the ba
tt
ery pack is charging, the blue-colored Ba
tt
ery LED should blink
slowly. If plugging in the AC-DC adapter does not trigger this blinking ac
ti
vity and
the LED stays dark, the ba
tt
ery pack may have been drained substan
ti
ally. Try
unplugging/ replugging the AC-DC adapter to the DT301C/ DT301S a few
ti
mes to
ac
ti
vate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Bu
tt
on to put the
tablet in “Standby” mode while not in use. Pushing brie
fl
y on the same bu
tt
on
will wake up the system within seconds.
NOTE:
Avoid using the Power Bu
tt
on (“hold 4+ seconds” feature) to turn o
ff
the
tablet—this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal opera
ti
on.
ENGLISH
4
5
ENGLISH
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate interface
will be displayed a
ft
er a launch sequence of several seconds. The wireless LAN connec
ti
on
may take 10-15 seconds to be established.
Con
fi
guring the Mobile Tablet
The DT301C/ DT301S may be con
fi
gured using the u
ti
li
ti
es and methods dictated by
the so
ft
ware opera
ti
ng system. The DT301C/ DT301S should be con
fi
gurable for various
proper
ti
es such as user pro
fi
les, network features, and several system elements.
Wireless Networking
Wireless LAN
The DT301C/ DT301S is o
ft
en delivered with an embedded (user-inaccessible) 802.11ac
WLAN adapter equipped with a hidden custom antenna.
T
•
hrough the support of typical WLAN adapters, the DT301C/ DT301S will detect
802.11 access points in the vicinity for you to select the access point of your choice
for connec
ti
on.
T
•
he SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT301C/ DT301S and
the access points have to match. The SSID is case-sensi
ti
ve and it is recommended
that you enable WEP/WPA/WPA2 encryp
ti
on (or advanced alterna
ti
ves) for secure
access.
W
•
hen WEP/WPA/WPA2 is enabled, you may need to consult your network admin-
istrator or your networking equipment literature to properly con
fi
gure associated
se
tti
ngs such as Authen
ti
ca
ti
on mode, etc.
R
•
efer to the access point opera
ti
ng manuals for se
tti
ng up the 802.11 access points.
