DTC COMMUNICATIONS, INC.
4
QUICK START GUIDE
1
Make sure that the ON/OFF switch is set to OFF.
(
Red
dot is OFF)
.
2
Install 4 “AA” batteries in the internal battery compartment of the module.
(Lithium batteries are recommended)
3
Using a screwdriver, turn the channel selector to the correct transmission
channel number.
4
Connect an antenna to the ANTENNA connector on the module.
5
Connect the microphone or microphones to the MIC-1 and MIC-2 connectors
on the module.
6
Connect a video source to the Video/Multi I/O connector.
7
Slide the power switch to the ON position (
Green
dot is ON) to apply power to
the transmitter.
Note: While installing the batteries, observe proper polarity as printed in the
battery compartment. Reverse polarity protection is a built-in design feature of
the transmitter. If a battery is installed backwards, this feature prevents the
transmitter from powering up, without damaging the transmitter or battery.
Warning: Do not apply power to the transmitter until an antenna has been
connected in step 4.
Warning: Refer to
Appendix A
of this manual for information on the proper
use of antennas.
5
7
1
4
6
3
2