I
WARNING
For the system to operate normally, please make sure JP3 of the mainboard is set as below.
Refer to Fig. 2 in this manual for the location JP3.
If JP3 is shorted to 2-3, no CMOS data can be retained.
CAUTION
The motherboard is an electrostatic sensitive device. Don’t open or handle except at a static-
free workstation.
Be sure to unplug the power code of the system when installation or upgrade with any
devices for the system.
POWER OFF
It needs to hold the power switch 4 seconds to turn off the power, if “Delay 4 sec” selected in
Power Management Setup of BIOS and ATX type power supply installed.
Windows, MS-DOS, and MS Word are trademarks of Microsoft Corporation.
Novell, Netware are trademarks of Novell, Inc.
Lotus, 1-2-3, and Symphony are trademarks of Lotus Development Corporation.
PC, AT, PC-DOS, OS/2 and Presentation Manager are trademarks of IBM Corporation.
UNIX is the trademark of AT&T.
Intel 810 and Socket 370 are registered trademark of Intel Corporation.
All other brand and product names are trademarks or registered trademarks of their
respective companies.
The information presented in this publication has been carefully checked for reliability;
however, no responsibility is assumed for inaccuracies, whereas, specification is subjected to
1 2 3
JP3
Summary of Contents for PRM-68I
