25 | Troubleshooting and Maintenance
5 C Adjusting The Print Line
Direction A
Direction B
When the print line is incorrectly set, the print quality on one
side of the medium may suffer. In such a case, the print line must
be adjusted so it is positioned parallel to the paper feed roller
Adjustment Methods
1. To move the print head in direction
A
as indicated by the
blue arrow, turn the adjustment wheel
anticlockwise
(see arrow 1).
2. To move the print head in direction
B
as indicated by
the blue arrow, turn the adjustment wheel
clockwise
(see arrow 2).
5 D Adjusting The Cutter (FX510ec Model Only)
While using the cutter, paper jams may occur. Please follow the below steps to clean the paper jam. A socket head screw for
adjusting the cutter is located on the bottom of cutter module, as shown in below illustration.
Cleaning Steps:
1. Switch off the printer.
2. Use a Phillips (cross-head) screwdriver to turn the socket head screw and release the knife.
3. When you have cleared the paper jam, switch on the printer again. The cutter will automatically reset.
Note:
Labels should be at least 30 mm high to ensure correct functioning of the cutter.
Socket Head Screw
Summary of Contents for FX510e
Page 4: ......
Page 31: ...FX510E 190305 ...