29 | Label and Ribbon Specifications
6 B Label Specifications
Max
Min
Label/Print Width
105.7 mm (4.16")
N/A
Liner Width
118 mm (4.64")
25.4 mm (1")
Label/Print Height/Length
762 mm (30")
4 mm (0.16")
Gap between labels
19 mm (0.75")
2.5 mm (0.10")
Distance from edge of media to edge of thru-hole
48.3 mm (1.90")
5.1 mm (0.20")
Reflective/Black Mark Width*
Equal to distance between labels 25.4mm (1")
Max. Outer Diameter (OD) internal feed
127 mm (5.0")
N/A
Max. Outer Diameter (OD) Passive Label Stand
250 mm (10.0")
N/A
Inner Core Diameter (ID)
76 mm (3")
25.4 mm (1.0")
Stock Thickness**
0.25 mm (10 mil)
0.06 mm (2.4 mil)
Distance from edge of media to edge of label
Printer driver assumes 2 mm gap. However, this is adjustable
via the Printing Preferences “Stock” – “Media Settings” – “Label
Gap”
* The Reflective/Black Mark should be opaque to infrared light. The mark should be between the labels. The end of the mark
should correspond with the beginning of the next label.
**This is the recommended maximum. There are two factors that determine whether the printer will accept any particular
stock thickness.
1. The ability for the printer to pull the paper through the print area.
2. The ability for the sensor to read through the backing if the sensor is set to die-cut.
If you are printing in continuous or reflective label sensing mode number 2 does not apply. The fact that the printer must read
through the backing in die-cut mode will limit the thickness much more than the printer’s ability to pull the paper through
the print area. However, if you adjust opacity level of the liner enough to allow the label to be seen by the stock sensor, the
thickness will only be limited by the printer’s ability to pull it through the printer area. For these reasons the weight or thick-
ness of the liner is a variable that can not easily be defined. DTM Print recommends and uses 70# liner with most label stock.
6 C Ribbon Specifications
Max
Min
Ribbon Length
300 m (981’)
N/A
Ribbon Width
110 mm (4.33")
30 mm (1.18")
Max. Outer Diameter (OD)
68 mm (2.67”)
N/A
Inner Core Diameter (ID)
25.4 mm (1”)
25.4 mm (1”)
Supported Ribbon Types
Wax, wax/resin, resin
Summary of Contents for FX510e
Page 4: ......
Page 31: ...FX510E 190305 ...
