SLICE6 DAS
User’s Manual
June 2018
support.dtsweb.com
11
13006-90010-MAN (Rev. 0)
SLICE6 DAS Maintenance
Periodically inspect 1) the connector contacts for proper alignment or other damage, and 2)
the sealing gasket surrounding the sensor interface connector and adjust if necessary. A
picture of the sensor interface connector and a properly installed gasket
(P/N 89100-19880-R) is shown below.
Power Management
A good power source is of paramount importance. SLICE6 DAS should be powered from a
SLICE6 Distributor. (One SLICE6 Distributor can support up to 4 SLICE6 DAS chains of up
to 10 DAS per chain for a total of 40 DAS or 240 channels.) Be sure to consider any power
drop due to cable length.
Power Consumption
Input Voltage
Deep Sleep
Idle
(On)
Data Download
(On)
Data Collection
(On and Armed)
9-15 VDC
1
12 mW
840 mW
900 mW
2.5 W
The SLICE6 DAS does not contain an internal battery and must be connected to external
power at all times for operation. Without external power applied, the SLICE6 DAS is in a
power off state.
With power applied, the DAS is either in deep sleep or on. If the ON signal is absent or
removed, the DAS enters deep sleep, the lowest power consumption state. With the ON
signal applied, power consumption is 840 mW-2.5 W, depending largely on the connected
sensor load and the unarmed/armed state of the unit.
Power-up and Power-down Procedures
When sufficient power is applied, the SLICE6 DAS will power up (on, idle and
communications enabled) if an ON signal is present. If an ON signal is absent, the unit will
initiate a limited power up sequence and immediately enter deep sleep. Power up (On state)
occurs within 15-30 seconds (static IP or DHCP, respectively), after which communication is
enabled. The unit enters deep sleep ~2 seconds after the ON signal is removed.
Power down of the DAS is immediate upon removal of external power. Wait ~30 seconds
before reinitializing the DAS.
1
Commercially-available 9 V batteries should not be used to power the SLICE6 DAS.
Summary of Contents for SLICE6 DAS
Page 20: ......
