TDAS G5 DAS
User’s Manual
October 2019
18
11000-00010-MAN (Rev. 5)
Using the New Settings
Use the following steps to update the system with the new network parameters:
1.
Reboot the hardware to force the system to use the new setting(s).
2.
Find the
tdas.ini
file in the TDAS Control program folder (normally c:\dts_tdas)
and make a back-up copy called
tdas_backup.ini
.
3.
Edit the file
tdas.ini
using Notepad or any text editor.
4.
Find the line titled
“Rack Inventory”
and change the IP address associated with
the serial number for the TDAS G5 DAS to the new address.
Note: Change only
the IP address and not the
DAS unit’s
serial number.
This is how the software will
know how to search for the DAS at the new IP address.
5.
Save the file.
6.
Confirm your computer’s Windows/network settings match the new TDAS
G5
network parameter(s). If changes are required to your computer, please contact
your network administrator for assistance.
7.
Start the TDAS Control software and confirm that the TDAS G5 DAS is found at
the new IP address.
