11
ZKL 3000 RC
7. CONTINUATION INSTALLING THE ZKL 3000 RC
• Carefully close the battery compartment, ensuring the cable stays within the specially cut
hole and lock it using the compartment key
• If you are not using an external battery, you must instead insert a secondary backup
battery. Please ensure you always use two batteries. If you use a second backup battery in
place of an external battery the power will only last around 24 hours and is therefore not
suited for long term deployment
• Apply the bypass clamps to the foot of the rails. The bypass clamps are linked to each contact
point of the ZKL 3000 RC. You connect these clamps to the rail by tapping them with a hammer
until they are fully placed on the base. This ensures below result.
• For further instruction on installing the bypass clamps, see Installation manual by-pass
ZKL 3000 (RC) V1.00 UK on www.dualinventive.eu
• Next, test the ZKL 3000 RC for functionality to ensure the ZKL 3000 RC can be switched on
and off and is visible in MTinfo 3000. See chapter “Functional test in the track”
• In case of any problems, DO NOT use the ZKL 3000 RC
b. Functional test in the track
Ensure your own safety at all times during the functional test.
The ZKL 3000 RC is now installed in the track and should next be function tested. It is important
that you
first read the other chapters before continuing.
ATTENTION!
If you are applying a short circuit with the ZKL 3000 RC in the same section,
the
distance to the ZKL 3000 RC should be at least 5 metres.
• Login on either MTinfo 3000 (https://MTinfo.dualinventive.com), an RS 3000 or the
Dual Inventive app
• Find the ZKL 3000 RC using its ID in the real-time status
• Click on the ZKL 3000 RC to verify the status
• For more information, see the manual: Using MTinfo 3000, chapter “Real-time status”
>
>
index
>
