2
Protect your marine radio from damage and the harsh marine environment with the
SG1/SG2 splashguard. This protective bezel and cover fits virtually any marine stereo on
the market and will protect against splashes and spray.
Before You Start
• Disconnect negative battery terminal. Consult a qualified technician for instructions.
• Due to differences in head units, it is recommended to temporarily mount head unit in
splashguard before installation to ensure splashguard cover will close properly.
Mounting Area
The diagram below illustrates proper placement of mounting holes to fit dimensions of
the unit.
Note:
Use extreme caution when drilling holes to avoid damaging fuel lines or existing
wiring.
Opening and Closing the Splash Guard
• Press down on release button on front of unit, and splashguard will open to allow
access to head unit.
• To close unit, press down on splashguard until it clicks into place.
SG1/SG2
INSTALLATION
Preparation
Release Button
9.0 inches
228.60 mm
2.0 inches
50.80 mm
3.5 inches
88.90 mm
8.25 inches
209.55 mm
1.125 inches
28.575 mm
7/32 inch
hole diameter
