Dual XGPS190, Owner'S Manual

XGPS190

XGPS190

10

11

Pairing with your device 

The  instructions  below  will  guide  you  through 

the  initial  pairing  process  which  connects  the 

XGPS190  to  your  tablet/smart  phone.  Once  the 

XGPS190  is  paired  with  your  device,  it  is  ready 

to use.
The XGPS190 can pair to two devices at a time. 

To pair to the second device, repeat the same in-

structions you followed for the first.
When  powered  on  subsequently,  the  XGPS190 

will  automatically  try  to  reconnect  to  the  last 

tablet(s) it was paired with. Keep this in mind when 

trying to use it with multiple devices: if you are hav-

ing trouble getting another device to recognize the 

XGPS190,  make  sure  the  last  device  you  used 

with  the  XGPS190  is  turned  completely  off  or  is 

out of Bluetooth range.
If the Bluetooth connection is interrupted while 

communicating, either because a device is turned 

off or because the distance between the two de-

vices is too great, you must turn the XGPS190 off 

and back on in order for it to automatically recon-

nect. Alternatively, you can go into your device’s 

settings menu and manually reactivate the link.
NOTE: Activating Airplane Mode on the iPad/

iPhone/iPod (which is recommended when flying) 

automatically turns off Bluetooth, so it must be 

manually turned back on. The recommended 

procedure with the iPad/iPhone/iPod is to activate 

Airplane Mode, turn Bluetooth back on and then 

turn on the XGPS190.
NOTE: The battery in the XGPS190 is already 

partially charged and the device should turn on 

the first time you take it out of the box. If the 

device does not turn on, please charge it from a 

USB source before continuing - see 

Charging 

on 

page 15. 

NOTE: If your device requests a code to con-

nect during the pairing process, use “0000” or 

“1234”.
Pairing the XGPS190 with the iPad, iPod touch 

or iPhone

(NOTE: these instructions were written using iOS 

version 9.0 and may be different if you are using a 

different version of the iPhone OS.)

• Turn on the XGPS190. The blue Bluetooth 

status light on the XGPS190 will start blinking 

slowly (about once per second).
• On the iPad/iPod touch/iPhone, go to:

Settings->Bluetooth

and turn on Bluetooth. The device will automati-

cally begin looking for the XGPS190.
• After a few moments, the XGPS190 will ap-