6
General Operation
XHDR6435
OPERATION
Faceplate Removal
Semi-Permanent
Faceplate Installation
Power On/Off
Mode
Auxiliary Input
Steering Wheel Interface
Input
Volume
Mute
Reset
Display
Set the Clock
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push
left side to secure.
Remove trim ring and install supplied #1 x 7/32” Phillips
head screw through left side of mounting frame into faceplate.
Press
or any other button (except eject) to turn the unit on.
Inserting a disc will turn the unit on automatically. Press and
hold to turn the unit off.
Press MODE to select between
AM/FM
, CD player, operation
of iPod, USB, auxiliary input and Bluetooth modes. Modes of
operation are indicated in the display.
Note:
"HD RADIO" will appear when the HDM90
HD Radio™
tuner is connected (sold separately).
CD mode will not
appear unless a CD is inserted. USB mode will not appear
unless a USB device is connected. Operation of iPod mode
will not appear unless an iPod device is connected. Bluetooth
mode will not appear unless the BTM60 Bluetooth module is
connected.
Insert 3.5 mm plug to connect your portable audio device.
The steering wheel interface input located on the back of the
head unit allows connection to the PAC (Pacific Accessory
Corporation) SWI-PS interface module (sold separately). Visit
www.pac-audio.com for details.
To configure steering wheel controls, follow the instructions
provided with the PAC SWI-PS interface module. After
installing the interface module, insert the module's 3.5mm
jack into the port on the back of the head unit.
Adjust volume using volume knob (00-46).
Press MUTE to silence the audio. “MUTE” will flash in the
display. Press MUTE again to cancel.
Press to RESET the unit upon initial installation or if
abnormal operation occurs. The reset button is located
behind the faceplate.
Press DISP to select between clock and different types of
information, such as radio frequency, CD track or MP3 CD/
USB song information.
With the unit on, press and hold DISP until the clock begins
to flash, then release. Press TUNE
nn
to adjust the
hours and TUNE
ll
to adjust the minutes. Press DISP
momentarily to save the selected time.
