Unpack the unit and components from
the box.
REMOVE ALL VISIBLE PACKING
MATERIAL, AND THOSE FROM
INSIDE THE COOKING CHAMBER.
Before using your new equipment, read
and understand all the instructions &
label associated with the unit prior to
putting it into operation. Make sure all
people associated with its use
understand the units operation & safety
before they use the unit.
Before making any electrical connection
to this unit, check that the power supply
is adequate for the voltage, amperage
and requirements stated on the rating
plate. A wiring diagram is included
herewith.
Disconnect the unit from the power
source before installing or removing any
parts.
Be absolutely sure that the ground con-
nection for the receptacle is properly
wired. Do not connect equipment to
power without proper ground
connection. Improper grounding may
result in personal injury or fatality.
INSTALLATION
3
This model is rated at 4.1Kw and has
to be permanently wired to 20Amp
switched isolating box. This machine must
be installed by a qualified electrician.
CONNECTION PARTS WILL BE
REQUIRED. THIS MODEL MUST NOT
BE OPERATED FROM A 13 AMP PLUG.
The power must be supplied via an 20A
all pole isolator which provides full
disconnection under overvoltage
category III conditions.
If a power supply cord is to be used, it
shall be at least 2.5mm
2
H05RN-F.
INSTALLATION
These models are rated below 3kW and
are connected to a normal 13 Amp, 3-pin
plug. If a moulded-on plug is not fitted or
has been removed, the new plug should
be fitted and wired accordingly.
Connect the green/yellow wire to the
terminal and the plug marked “E”
(EARTH) or by the earth symbol, or
coloured green or green/yellow. Connect
the blue wire to the terminal marked “N”
(NEUTRAL) or coloured black. Connect
the brown to the terminal marked “L”
(LIVE) or colour red.
MODEL DCTT 1 & 2
MODEL DCTT 3
The unit was shipped fully assembled and ready to plug into a standard outlet (See
below for DCTT3 for connection information) specified for its voltage and amp draw. If
improper electrical supply is determined, contact a qualified electricaian prior to
using the unit. Removal and replacement of the power cord and plug will void the
warranty. For assistance, contact your local authorised service agent for services or
required maintenance. Before using the unit for the first time, wipe down the exterior
with a damp cloth. Allow enough space around the toaster for adequate ventilation.
Do not operate the unit without the crumb tray properly position. Overheating and
poor toasting may occur. Read all labels on the unit and follow their instruction.
dctt2 ib 0310.qxp 03/03/2010 10:18 Page 3
