The toaster is equipment with a
thermostatically controlled device that
will automatically cycle the elements to
maintain the correct toasting
temperature.
The elements will cycle On/Off and
sometimes will appear to be Off but are
actually in automatic standby mode.
(saving 25% energy).
When bread is inserted into the toaster
the elements will automatically come
back on within 10-12 seconds.
If for any reason the ambient
temperature in the control box exceeds
190°F (88°C) a safety cut-out is
automatically activated.
This can be reset manually by pushing the
red button underneath the toaster on the
right hand side.
CAUTION:
DO NOT OPERATE UNIT
WITHOUT CRUMB TRAY IN PLACE.
THE UNIT WILL OVERHEAT AND
ACTIVATE THE HEAT LIMIT CUTOUT.
DO NOT HOSE DOWN THE UNIT OR
TABLE/COUNTER WHICH IT IS ON
AND KEEP AWAY FROM RUNNING
WATER.
•
To clean the conveyor belt: set the
‘POWER’ control to ‘POWER SAVER’.
For a lightly soiled conveyor belt, turn
conveyor speed to the slowest
setting and wipe the front of the belt
with a damp cloth.
For a heavily soiled conveyor belt,
turn conveyor speed control to
slowest setting (setting 1) and wipe
with a dry, light abrasive pad.
•
After the unit cools, disconnect unit
from power, remove interior crumb
tray and clean. Slide crumb tray back
into position after cleaning.
•
Never allow a build up of crumbs
in the tray as this may cause a fire.
CLEAN ON A DAILY BASIS.
•
Ensure the cooling fan is clear of dust
and grease.
CLEAN AIR INTAKE
FILTER COVER EVERY ONE TO
THREE MONTHS.
•
Once fully cooled.wipe exterior
surface of unit using a damp cloth
6
1. MY TOAST IS BURNING OR IS
UNDERDONE:
a)
The ‘TOAST’ control should be set at
the triangle mark; this can be adjusted
to taste, and will take a few seconds to
settle. If toasting is too light, turn
conveyor ‘TOAST’ control
anti-clockwise to a lower speed to
darken. If toasting is too dark, turn the
‘TOAST’ control clockwise to lighten.
b)
Allow 10 minutes for the conveyor to
heat up when switched on.
c)
If the toaster has been left on ‘BOTH’
power without bread passing through
it, the first slices through may burn
due to build up of heat. When the
toaster is in an idle period, we advise
that the toaster is set to the ‘POWER
SAVER’ setting. This will prolong the
life of the elements and reduce
un-even toasting when used again
after the idle period.
2. MY BREAD IS GETTING STUCK
INSIDE THE TOASTER:
a)
Ensure the thickness of the bread is no
thicker than 30mm or it will get stuck
and may cause a fire.
TROUBLESHOOTING
CLEANING
TCF
RESET SWITCH
dctt2 ib 0310.qxp 03/03/2010 10:18 Page 6
