3. THE ELEMENTS CYCLE ON & OFF:
a
a)) The toaster is equiped with a
temperature monitoring device that
will automatically cycle the elements to
ensure the perfect toasting
temperature.
The elements will cycle On/Off and
sometimes will appear to be Off but
are actually in automatic standby
mode. (saving 25% energy on Auto
Standby).
4. MY CONVEYOR IS OVERHEATING:
a)
If the conveyor belt continues to run
and the elements have cut out, check
the cooling fan is running and is free of
dust and dirt. The heat limit switch
may have been activated. If the fan is
dirty, isolate from the power and clean
with a soft brush, leave for ten minutes
for the toaster to cool and push the
reset button to begin toasting again.
(Allow time for the toaster to heat up
again).
b)
Allow a clearance of 80mm from the
rear of the machine and 30mm gap
either side.
If your conveyor toaster fails within one
year from date of purchase we will repair
or replace it free of charge, except for the
elements, provided:
•
You have not misused, neglected
or damaged it.
•
It has not been modified.
•
You supply your receipt to show
when you bought your toaster.
ELEMENTS ARE GUARANTEED FOR 3
MONTHS FROM DATE OF PURCHASE
FOR PARTS & LABOUR, THEREAFTER
PARTS ONLY.
The guarantee does not affect your
statutory rights.
If over one year, contact Dualit for
recommended repair agents.
Further advice on using your Dualit
conveyor toaster and other products in
the Dualit range is available from:
Dualit Care Line: +
+4
44
4(
0) 1293 652 500
(09:00 to 17:00 Monday to Friday)
Or email us on
info@dualit.com
c)
The toaster will also overheat if the
crumb tray is not in position when in
use. This acts as heat screen and helps
protect the internal components vital
to the running of the toaster.
5. WHERE DO I POSITION THE
CONVEYOR TOASTER:
a)
Ensure there are no shelves or units
directly above the conveyor.
b)
Allow ample clearance around the
conveyor, minimum 80mm at rear and
30mm at sides. This ensures air can
circulate around the conveyor and
keep it at optimum operating
temperature.
c)
Do not cover or obstruct the fan.
6. MY ELEMENTS HAVE GONE WHITE:
a)
Dualit conveyors use silica glass tube
elements. These may go white over
time. Deposits of starch from the bread
may build up on the element. This in
not harmful in any way nor does it
effect the toasting performance.
GUARANTEE
TROUBLESHOOTING
7
dctt manual 2008.03.07.qxp 11/06/2008 11:52 Page 7
