14
15
Unplug the Steriliser from
the mains and allow to cool
down completely before
cleaning.
Once a month, press the UV
and Dry cycle button to clean
and deodorise the insides of
the UV Steriliser, Upper Rack
and Lower Rack, with nothing
else inside it.
Wipe the interiors clean with
a soft, dry cloth.
Once a year, replace the two
UV-C Purification bulbs for
maximum sterilisation. Make a
note of when you first used/
replaced the bulbs to ensure
that you replace annually.
3
For water stains, wipe the
interiors with a warm, damp
cloth followed by wiping
down with a dry cloth (do not
wipe the bulbs).
1
4
CLEANING & CARE
Before cleaning make sure the machine is switched off, unplugged
and allowed to cool. Dualit recommends cleaning your UV Steriliser
after every use.
Do not submerge the Body, Power Cord or
plug into water or other liquid, or position under a water
tap. Do not use sharp, abrasive or aggressive cleaning
agents, bleach or scouring pads to clean the UV Steriliser. The use of such
cleaning implements may affect the life of the UV Steriliser.
U
N
PL
U
G
WH
EN NO
T IN
U
SE
When not in use,
clean and dry the UV
Steriliser and store
in a cool, dry place.
Not replacing the
bulbs can result in
risk of bacterial or
viral contamination.
2
5
x1 15min
x2 25min
x3 Cancel
BEEP!
Plug in the UV Steriliser to the
mains. Repeatedly touch the UV
and Dry Function Button to scroll
through to your preferred time,
refer to the function & program
chart on P11. The inside of the
UV Steriliser will illuminate Red
then Blue. Tip: For particularly
wet items, run on a Dry Function
first.
Only place clean items into
the product. Wash dirty items
with warm soapy water. Always
shake off excess water from
washed products before placing
in the UV Steriliser.
When the function ends the
UV Steriliser will beep once
and the interior light turns
off. Items will remain sterile
for up to 24 hours as long as
you do not open the door.
Place items upright, facing
the UV light.
Warning: Do
not stack. Items need to
be exposed to the UV
light to sterilise.
Open the door and remove
your products. Unplug the
UV Steriliser when not in
use, then follow cleaning
instructions on page 15.
Ensure larger items do not cover
or block the circulation vents.
Place bottle teats upside down in
the round rings installed on the
Upper Rack. This increases the
sterilisation efficiency.
4
1
5
2
6
3
USING UV AND DRY FUNCTION
Do not open the door mid-cycle as items will not be sterilised. If you need to add or remove
an item, cancel the cycle and start it again. Tip: Efficiency decreases if there is residual moisture
in the product.
Before using this function check UV-C Bulbs are working by pressing UV Button. Both Bulbs
should glow and the Chamber will illuminate Blue, press UV twice to end cycle.
x1 35mins
x2 55mins
x3
End Cycle
