15
Attention:
Electronic boards have a limited memory capacity up to 10 channels. (Each button of the remote
corresponds to 1 channel).
If you need more storage capacity available is an optional external receiver 4-channel model Rixy 6040 (6040Rol)
witch has a capacity of 40 codes storage or more upon request).
B) How to cancel the codes storage on the electronic board.
In the event that the memory card is full or in case there is a need to delete some codes you will need to perform
this procedure:
1 - Press and hold P1 for about 30 seconds until the red LED will emit a series of flashes and then
2 - release P1,
at this point all the codes have been eliminated, in order to re store a remote control code, repeat the
procedure as per point A).
QUICK SoLUTIon oF PRoBLEMS RELATIng To RADIo ConTRoL
First verify that the card is properly powered (check the fuse/s).
If only 1 radio control does not work:
1) make sure that the remote control is compatible with automation.
2) replace the battery of the remote control (although LED lights up). A low battery may affect the flow rate and
/ or the transmission itself.
3) it is possible that the memory of electronic board is full. Delete all code and re- enter the codes in use (up to
card capacity).If all remote controls do not work there may be a problem with the radio receiver.
Test if a wired control (key switch) works properly and contact the after sales service of manufacturer.
WARnIng: Before proceeding, verify that:
1) The trimmer “Time” must be fully rotated Anti-clockwise = “0” position which corresponds to the operation of
the system in semi-automatic mode ( step by step )
2) The trimmer “Power” must be fully rotated CLOCKWISE = setting power to the maximum FIG.16 - 17/A
ATTEnTIon:
ALL ADJUSTMENTS SHOULD BE MADE TO THE GATE CLOSED.
The regulations will be effective only in the next cycle.
13. MAgnETIC LIMITS FInAL FIXIng
To find the final position of the magnet:
perform opening and closing cycles taking care to move each time the limits a few centimeters bringing them
closer to the their final position.
This will make it possible to perfectly adjust the magnets, preventing the gate stops on the mechanical stop
before detecting the magnet.
14. WIRIng
For versions with electronic board CTH43 see FIG.16
For versions with electronic board CTH46 see fig.17A -17B
PoWER
ADJUSTMEnT
: potentiometer “PoWER”
Turn the trimmer clockwise to increase engine power. This will decreases the reaction time in case of obstacle
detection.
The level of power / sensitivity should be adjusted according to weight of the gate gate. Use the minimum power
necessary for the proper handling of your gate.
The seasonal changes may result in a change in the friction and you may need to periodically adjust the power .
ADJUSTIng METHoD oF CLoSIng: Step by Step or Automatic
potentiometer “TIME” allows you to set two modes of operation:
A) Semi-automatic or step-by-step use
For this mode, rotate the trimmer completely anti-clockwise. By pushing your remote control the the gate will
open and will stay open until it receives a new command.
B) Automatic closing
to set this mode, turn the trimmer TIME CLOCKWISE until you reach the desired pause time before the gate
closes automatically (max. 100 sec when turned fully clockwise).
WARnIng:
in this mode the opener do not accept any signal from the remote control while in pause time.
ATTEnTIon:
ALL ADJUSTMENTS SHOULD BE MADE TO THE GATE CLOSED and will be effective only in
the next cycle.
