24
ENGLISH
L2003212 Installation guide for DucoBox Energy Comfort (Plus) (Revision A | 18.10.2022)
Replacing a component
1
Activate ‘Installer mode’ by long-pressing 2 diagonal buttons on a paired control� The LED will
flash green rapidly�
5 sec
2
Briefly press twice on the button of the component to be replaced�
2x
OLD
3
Tap once on the button of the new component� The latter will take on all settings / connections in
the network�
1x
NEW
3
Deactivate ‘Installer mode’ by pressing the 4 buttons on a paired control simultaneously (or using
the palm of your hand on a control featuring touch buttons)� The LED will turn white�
07.C
Tips
The network can be wiped or a full reset of the DucoBox Energy Comfort (Plus) can be carried out in the event of any problems� To
do this, refer to the following functions under the
INSTALLATION
menu (visible only after activating advanced mode, see page 31)�
•
RESET NETWORK
: this removes all paired control components from the network�
•
FACTORY RESET
: this resets the entire system (= DucoBox Energy Comfort (Plus) + paired components) to factory settings� The
calibration will be lost�
Use the DUCO Network Tool or the DUCO Installation App to read out information from components�
Never pair more than one system with RF components at the same time. This could result in components on the wrong system
being paired or in components failing to respond�