6.
O P E R A T I N G T H E T O O L
Read Safety Instruction section of this manual.
Loading the tool:
WARNING:
Always connect air before loading the tool.
Always wear safety goggles when operating the tool.
1.
Open the magazine.
Pull down door latch and swing the door, then swing
magazine cover open.
2.
Check adjustment.
The pin support can be adjusted up and down for
three settings. Set the position of the pin support
according to the pin length. The pins will not feed
smoothly unless the magazine is not adjusted
correctly. To change setting pull up on the post and
twist to the correct step.
3.
Load the coil fasteners.
Place a coil of fasteners over the post in the
magazine. Uncoil enough of the pins to reach the
feed pawl, place the first pin in front of the feed pawl
into the driver channel and place the second pin
between the teeth of the feed pawl. The heads of the
pins must be in the slot in the nose.
4.
Close the magazine.
Close the magazine cover and swing the door closed.
Be sure that the door is fully latched when released.
The tool is now ready to operate.
TEST OPERATION
1.
Adjust the air pressure at 80 p.s.i. (5.5 bar) and
connect the air supply.
2.
Without touching the trigger, depress the safety nose
against the work-piece. Pull the trigger. (The tool must
fire the fastener.)
3.
With the tool off the work-piece, pull the trigger. Then
depress the safety nose against the work-piece. (The
tool should NOT fire the fastener.)
4.
Adjust the air pressure as much as the lowest possible
according tot he diameters and length of fastener and
the hardness of work-piece.
