10.3 Cutting block adjustment
Caution: Danger of injury !
Switch the main switch off.
Adjust the cutting block only with the machine switched off.
The cutting length can be altered by changing the cutting block.
The cutting length is determined by the cutting block length.
Standard checking
The cutting block 3 must be in parallel position to the cutting knife 4.
The cutting block stop 5 has to be adjusted so that the knife mark on
the cutting block 3 reaches the indicated cutting length.
Correction
–
Loosen screws 1.
–
Adjust the cutting block 2 laterally to the cutting knife 4.
–
Tighten screws 1.
–
Loosen screw 2.
–
Adjust the cutting block 3 in longitudinal direction to the cutting
knife 4.
–
Tighten screw 2.
–
Loosen screw 6.
–
Position the stop 5 close to the cutting block.
–
Tighten screw 6.
32
4
3
2
1
6
5
