–
Adjust the looper’s position.
–
Put the sewing machine down.
–
Press the “
OK
” key.
The sewing motor drives back to testing position 2.
–
Check the looper’s position.
–
Press the “
OK
” key.
The sewing motor drives to testing position 3 (right looping stroke).
The display reads:
6 1 0
0 2
–
Check the looper’s position and, if needed, adjust according to the
above mentioned description.
With each further pressing the “
OK
” key, the next sewing instrument’s
testing position appears.
–
Select the positions one after the other and check their settings.
Position
Setting
1
Setting the locking positions (see chapter 2)
2
Left looper to the needle’s middle (see chapter 12)
3
Right looping stroke (see chapter 12)
4
Needle bar height (see chapter 13)
ATTENTION!
Contrary to chapter 13, with this setting a position is selected, so that
the complete needle’s eye is to be seen under the left looper tip.
5
Left needle guard (see chapter 15)
6
Right needle guard (see chapter 15)
7
Left spreader opened (see chapter 16)
8
Left spreader closed (see chapter 16)
9
Right spreader opened (see chapter 16)
10
Right spreader closed (see chapter 16)
62
