5.4
Adjusting and connecting the pedal
Stand set for longitudinal installation and stand set for
transversal installation
–
Adjust the pedal 1 on the stand strut 2 sideways so that the middle
of the pedal stands more or less under the middle of the needle.
–
Screw the pedal 1 to the stand strut.
Stand set for transversal/longitudinal operation
When using this stand set, the pedal can be adapted to the different
working positions as follows:
–
Lift the ball handle 3.
–
Turn the pedal platform 4 according to the working position and let
the ball handle 3 engage in the end position.
For all stand sets
–
Screw set point generator 5 to the stand.
–
Introduce the plug of the set point generator 5 into the bush 6 of
the control box.
–
Suspend the pedal rods 7 in the set point generator 5.
–
Loosen slightly the clamping screw 8.
–
Adjust the pedal rods so that the released pedal 1 has an
inclination of about. 10°.
–
Tighten the clamping screw.
6
5
8
7
2
1
3
4
10
Summary of Contents for 577-1111
Page 2: ...Fig A 10 4 6 13 14 1 5 12 7 8 9 11 2...
Page 5: ...1 2 3 5...
