18
2. Projecting an Image (Basic Operation)
3. Press the
(POWER) button on the projector cabinet
or the POWER ON button on the remote control.
The POWER indicator goes from a steady red light to a
flashing blue light, and the picture is projected on the
screen.
TIP:
• When the message “PROJECTOR IS LOCKED! ENTER YOUR
PASSWORD.” is displayed, it means that the [SECURITY]
feature is turned on. (
→
page
)
After you turn on your projector, ensure that the computer
or video source is turned on.
NOTE: The blue screen ([BLUE] background) is displayed when no
signal is being input (by factory default menu settings).
Standby
Blinking
Power On
Steady red light
Blinking blue
light
Steady blue
light
(
→
Performing Lens Calibration
After installation or replacement of the lens, be sure to perform
[LENS CALIBRATION] by pressing and holding the SHUT-
TER/CALIBRATION button on the projector cabinet for at least
two seconds or by holding the CTL button and pressing the
INFO/L-CALIB. button on the remote control. Perform [LENS
CALIBRATION] also when trouble is found on the lens shift
motion. Calibration corrects the adjustable zoom, shift, and
focus range. If calibration is not performed, you may not be
able to get the best focus and zoom even if you adjust the
focus and zoom for the lens. While performing Lens Calibra-
tion, the STATUS indicator flashes in green twice per cycle.
• The following lenses need calibration:
NP16FL, NP17ZL, NP18ZL, NP19ZL, NP20ZL, NP21ZL,
NP31ZL
