Process Utilities, Continued from Previous Page
Erase Setup
Setup parameters can be erased for the current setup, or
for all setups. A screen will pose the question, "
Are you
sure you want to erase all setups?
" Answer
Yes
or
No
to proceed with the erase process.
See Figure 5-47 to the right.
Part Count Settings
This utility permits part count modification through its
three submenus:
Reset Part Count
- Selecting this sets the part count
to zero (0). Therefore the next cycle completed would
create part number one (1).
Preset Part Count
- Enter a number that starts the
part counter.
Count Bad Parts
- Enable this to increment the part
count if a bad part occurs.
Clear Bad Part -
Enable this to allow the opera-
tor to clear a
Bad Part Limit Exceeded
message
displayed on the front panel. Allowing the operator
to clear the bad part message will also reset the bad
part latch.
See Figure 5-48 to the right.
Language
The language displayed by the front panel is made through
this utility.
Base Units
Select either
Imperial
or
Metric
units with this utility.
Date Format
The date utility allows for three ways to display the date:
• Month/Day/Year -
MM/DD/YYYY
• Day/Month/Year -
DD/MM/YYYY
• Year/Month/Day -
YYYY/MM/DD
Time
This utility is used to set the current time.
Date
Entering the current date will be done in the date format
already chosen.
Figure 5–47
Erase Setup
Figure 5–48
Part Count Settings
Process Utilities, Continued
Page 72
iQ Series
Ultrasonic Generator/Power Supply, Servo Systems, ES User’s Manual
Dukane Manual Part No. 403-587-00
