Page 15
Section 3 – Installation
Dukane Manual Part No. 403-591-01
Placement in a Seismic Region
If the
iQ
generator is to be used in an active seismic region,
secure the unit by rack-mounting it or by securing the unit
to a benchtop.
Refer to Dukane’s website for more information about
installation in a seismic zone. See Application Note AN511
https://documents .dukane .com/AppNote/An511 .pdf
Mounting
Brackets
Figure 3-1
Mounting Brackets - Rear and Bottom
NOTE
For equipment weights see Page 54, in
Section 8, Specifications
.
NOTE
Heat Dissipation -
Provide enough air
flow for heat dissipation. For best heat dis
-
sipation, mount the generator vertically as
shown in Figure 5-1 on page 35.
Unpacking
Carefully open your shipping container, and make sure
it contains the items shown on the shipping documents.
Inspect all items, and report any missing items or damage
immediately.
Placement
Make certain generator placement and cable routing do
not interfere with normal operation. Maintain easy access
to your equipment.
The operator should have unobstructed access to cables
and wiring.
Two sets of removable mounting brackets are attached
to the generator. See Figure 3-1, below. Use them to
securely mount the unit vertically or horizontally in your
equipment cabinet.
If the generator is installed inside an enclosure with a
door, be sure there is adequate clearance for the system
cables with the door closed.
