Page 7
Page
iQ Series
,
Ultrasonic Generator/Power Supply LS User’s Manual
Section 4 – Standard Connections
Dukane Manual Part No. 403-574-01
Page 7
Page
iQ Series
,
Ultrasonic Generator/Power Supply LS User’s Manual
Section 4 – Standard Connections
System Inputs Signal Descriptions
Pin 1 (+22V)
This pin can 22VDC at up to 250mA to power
the user’s automation controls.
Pin 2 (Power Gnd)
Pin 2 is the 22VDC return and is tied to the system chas-
sis ground.
Pin 3 (Remote Setup Selection Bit 0 Input)
Pin 3 is the Remote Setup Selection Bit 0, which is the
least significant bit used to select different welding set
-
ups with an automation control system. This input is also
used to select different channels when a Multiple Probe
Controller (MPC) Interface option board is installed.
Pin 4 (Remote Setup Selection Bit 1 Input)
Pin 4 is the Remote Setup Selection Bit 1, which is the
second least significant bit used to select different weld
-
ing setups with an automation control system. This input
is also used to select different channels when a Multiple
Probe Controller (MPC) Interface option board is in-
stalled.
Pin
Signal Name
Cable Color Code
Signal Option Requirements
1
+22V
BLK
2
Power Ground
WHT
3
Remote Setup Selection Bit 0 Input
RED
MPC Option Required
4
Remote Setup Selection Bit 1 Input
GRN
MPC Option Required
5
Remote Setup Selection Bit 2 Input
ORN
MPC Option Required
6
Remote Setup Selection Bit 3 Input
BLU
MPC Option Required
7
Remote Setup Selection Bit 4 Input
WHT/BLK
Not Used
8
Ultrasound Activation/Cycle Start Input
RED/BLK
9
Automation Thruster Control Input
GRN/BLK
Automation Thruster Board Required
10
Front Panel Control Lock Input
ORN/BLK
11
Press Inhibit for Hand Probes
BLU/BLK
Hand Probe
12
System Latch Reset Input
BLK/WHT
13
Isolated Common
RED/WHT
14
Not Used
GRN/WHT
15
Automation Cycle Stop Input
BLU/WHT
Figure 4 - 4
HD-15F, Generator Input Connector
Figure 4 - 5
HD-15M, Generator Input Cable
Connector
1 2 3 4 5
6
10
11 12 13 14 15
5 4 3 2 1
5 4 3 2 1
15 14 13 12 11
15 14 13 12 11
6
6
10
10
Table 4 - I
System Input Connector Signals (J2)
