Page 75
Section 10 - Options
Dukane Manual Part No. 403-574-01
I/O Panel Options
Single Connector System I/O Panel
See
B
in Figure 10-4 where the I/O panel is set up for the
single I/O connector, a HD15F type. The generator label
for this connector is,
SYSTEM INPUTS/OUTPUTS
.
Another label identifies the connector as J12.
The I/O panel can be customized with multiple types of
connectors such as the single HD15F, terminal blocks,
etc. Contact your local sales representative for more
details
.
Table 10-I shows an example of a customized option:
Pins/Signals duplicate a Dukane DPC-I generator.
5 4 3 2 1
5 4 3 2 1
15 14 13 12 11
15 14 13 12 11
6
6
10
10
Figure 10 - 3
HD15F for System Inputs/Outputs
Connector
Figure 10- 4
Option Panel and I/O Panel
(NOTE: Shown are the Option panel with Remote
Control Module, and the I/O panel with single I/O
connector.)
Option Panel
I/O Panel
B
Pin
Signal Name
Signal Description
1
+
22VDC
Current limited to 250mA maximum
2
Ground
22VDC Return (chassis ground)
3
Ground
Status Outputs/Driver/Monitor Return
4
Status Driver
Status Driver Output (1 Amp max.)
5
Ultrasound Active Status
Ultrasound Status Output (Active Low)
6
Overload Fault Status
Overload Fault Output (Active Low)
7
Isolated Operate Input Common
Isolated Operate Input Common (7 & 8) JU726
8
Operate Input
Sw Closure Operate Inut (2 & 8) JU724/725
9
Over Temperature Fault
Over Temperature Fault Output (Active Low)
10
System Fault
System Fault Output (Active Low)
11
Not Used
Reserved - HPPI Signal
12
Amplitude Setting
Amplitude Setting Monitor (10.0V = 100%)
13
Power Signal Common
Power Signal Common
14
Power Signal
Power Signal Monitor Output (1mV = 1 Watt)
15
Loop Fault
Current Loop Fault Output (Active Low)
Table 10- I
HD15F Example of Customized System Inputs/Outputs Connector Signals
A
