background image

2

Installation and Operation of: Front Line Merchandiser

TABLE OF CONTENTS 

Important Safety Instructions .............................................................................................................. 2-3

Specifications

 ........................................................................................................................................ 4

Tools Required....................................................................................................................................... 4

Unpacking Unit ...................................................................................................................................... 5

End Glass Removal ............................................................................................................................... 5

Installation ............................................................................................................................................. 6

Maintenance .......................................................................................................................................... 8

Electrical shock hazard. Do not wash with water jet or hose. 

IMPORTANT SAFETY INSTRUCTIONS

Throughout this manual, you will find the following safety words and symbols that signify 

important safety issues with regards to operating or maintaining the equipment.

 

Indicates a hazardous situation which, if not avoided, could 

result in death or serious injury.

 

Indicates a hazardous situation which, if not avoided, could    

 

result in minor or moderate injury. 

     

 

Indicates Important Information

 

                 

 

Indicates electrical shock hazard which, if not avoided, could 

result in death or serious injury and/or equipment damage.

                 

  

Indicates hot surface which, if not avoided, could result in 

minor or moderate injury. 

Summary of Contents for FLM200









Reviews: