www.factorybuysdirect.com
200423-01A
11
INSTALLATION
WARNING: Do not allow any
combustible materials to overlap
the firebox front.
WARNING: Do not allow
combustible or noncombustible
materials to cover any necessary
openings like louvered slots.
WARNING: Never cover any
air inlets on the front of the
firebox.
Built-in installation of this fireplace
involves installing fireplace into a framed-
in enclosure. If installing a built-in mantel
above the fireplace, you must follow the
clearances shown in Figure 3.
Notice: Surface temperatures of adjacent
walls and mantels become hot during
operation. Walls and mantels above the
fireplace may become hot to the touch. If
installed properly these temperatures meet
the requirement of the national product
standard. Follow all minimum clearances
shown in the manual (see Figures 3 and 4).
1.
Frame in the rough opening. Use dimen
-
sions shown in Figure 4 for the rough
opening. If installing in a corner, use di
-
mensions shown in Figure 6, for the rough
opening. The height is 23 1/4, which is the
same as the wall opening
2.
Carefully set fireplace in front of rough
opening with back of fireplace inside wall
opening.
3.
Attach gas line to fireplace gas regulator.
See Connecting to Gas Supply, page 18.
4.
Check all gas connections for leaks. See
Connecting to Gas Supply, page 18.
IMPORTANT: When finishing your firebox, materials
such as wall board, gypsum board, sheet rock, exterior
wallboard, plywood, etc, must have 3/4" clearance to
the sides and top of the firebox. Combustible materials
should never overlap the firebox front.