with bolts on the position as picture shows. (Fig.4)
For bar handle:
To rotate door at 180 degrees, then assemble the
door as per the reverse way of remove. (please see
Fig.4)
For other handle:
Install the door as per reverse way of remove.
(please Fig.4)
DESIGN 2 – For tall models
①
Upper hinge
②
Hinge shaft
③
Hinge buckle
④
Upper hinge
⑤
Lower hinge
⑥
Glass door
1. As shown in Figure 1, use a flat-blade screwdriver
to open the upper hinge buckle
③
to see the hinge
shaft
②
, and then use a flat-blade screwdriver to pry
the hinge shaft
②
and take it out. Then unscrew the
lower hinge in the same way.
2. As shown in Figure 2, the installation method of the
upper part of the door is the same as the lower part.
3. When the upper and lower parts are removed, pull
the door parallel to the outside. The door can be
taken out.
4. Remove the glass door, use the hex wrench to
remove the upper door hinge and the lower door
hinge mounting screws, and remove the upper and
lower door hinges.
5. Pay special attention to this: 1) The glass door is
turned 180 degrees to install, and the lock hook and
magnet of the door are removed and reinstalled to
the other side. 2) The upper hinge and lower hinge
are also exchanged at the same time.The right upper
hinge is changed into the left lower hinge. The right
lower hinge is changed into the left upper hinge.
Becomes the lower door hinge and becomes the
upper door hinge when the right lower door hinge is
changed to the left side.
6. Install the door hinge first as shown in Figure 3 and
install the lower door hinge as shown in Figure 4.
7. Lift the door as shown in Figure 4. Firstly, insert the
lower hinge into the corner fittings, align the mounting
holes, and insert the hinge shaft
②
into the hinge
hole in position. Then cover back the Hinge buckle
③
. The installation of the lower part of the door is
completed.
8. Install the upper part of the door as shown in
Figure 3, the same method as the lower part of the
installation door. In the end the door revert is finished.
9. Install the door hinge Note: When installing the
upper door hinge, please move the door hinge to the
side of the outer casing and then tighten the screw.
After the lower door is installed, move the screw to
the inside of the outer casing and tighten the screw to
prevent the door from falling.
CHANGE THE DOOR ALARM PARTS WITH
INVISIBLE HINGE
①
Door
②
Look
③
Door alarm Magnet
④
Magnet Fix hole
⑤
Lock fix hole
1. After change the door, first unscrew
②
Look and
③
Door alarm Magnet like pic1.
2. Then fix the
②
Look to the position of
⑤
Lock fix
hole.
3. After change the
③
magnet to position of
④
magnet fix hole
OPERATING YOUR APPLIANCE
This appliance is designed for operation at certain
ambient temperatures. The climate class is specified
on the rating plate.
The appliance may not work properly if it is left for a
long period at a temperature outside the specified
range. For example, placing your unit in extreme
cold or hot conditions may cause interior
temperatures to fluctuate. The range between 5ºC
and 20ºC (41ºF and 68ºF) may not be reached.
Climate class
Ambient room temperatures
